MIDWESTWHEEL.COM IOWA MISSOURI DES MOINES 1436 E. Ovid Ave. office 515.265.1491 fax 515.265.4120 parts fax 800.314.4329 parts 800.888.0248 CEDAR RAPIDS 200 50th Ave. S.W. main 319.365.4453 fax 319.365.6327 parts fax 877.706.6085 parts 800.332.5435 DAVENPORT 8502 Northwest Blvd. main 563.322.2671 fax 563.322.5940 parts 800.553.1886 SIOUX CITY 1819 4th St. main 712.252.7969 fax 712.252.6149 parts 800.943.3534 CLEAR LAKE 840 Hwy. 18 W. main 641.357.7101 fax 641.357.8190 parts fax 800.548.9674 parts 800.397.5630 TRUCK PARTS SUPER STORETM KANSAS CITY 5801 E. Front St. main 816.471.1552 fax 816.471.0813 parts 800.821.7402 JOPLIN 2424 Stephens Blvd. main 417.717.6022 fax 417.782.7126 parts 866.318.9111 August 2022 (33Bendix Reman Steering Gears and Power Steering Pumps) 3C REMOTE FILL CANISTERS ONLY Drain all fluid from canister assembly Remove filter element in canister assembly Clean and inspect canister Install new replacement filter assembly into canister 4 PULLEY TYPE PUMPS ONLY Re-install pulley assembly onto pump assembly 5 INSTALL PUMP ASSEMBLY 5A DIRECT DRIVE PUMPS Remove all dirt & oil from the engine external pump mounting surface prior to re-installation Install pump assembly with correct gearing set-up or coupler and correct gasket or o-ring mounting seal. 5B PULLEY DRIVE PUMPS Clean inspect brackets for damage or wear Re-mount pump into bracket assembly correctly Re-install fan belts Do not over tighten fan belts 6 FLUSHING THE STEERING SYSTEM Connect the bypass/hose (pump to tank) if used in application Connect psi outlet hose from pump to gear assembly Position return/feed hose from gear box going to pump or canister into a suitable container Plug return opening at canister to prevent drainage Fill and maintain fluid level in canister with new fluid only Have vehicle front end tires unloaded (lift front end off the ground) Steering vehicle front end from axle stop to axle stop (engine shut off) Maintain oil level in canister at all times Crank over vehicle engine without starting to induce steering fluid into hydraulic system Maintain oil level in canister at all times Steering vehicle front end from axle stop to axle stop with engine off Repeat procedure until fluid runs clean from return line. Reconnect return line gear to pump assembly or canister 7 Check fluid levels and steer vehicle front end axle stop to axle stop with engine running unloaded 8 Load steering axle on floor and steer from axle stop to axle stop with engine running 9 BLEED STEERING SYSTEM AS PER MANUFACTURES SPECIFICATIONS 10 Check and fill fluid levels to manufacturer specifications IMPORTANT Power Steering Pump Installation Procedure, Continued FAILURE TO FOLLOW THESE INSTALLATION PROCEDURES CAN VOID THE WARRANTY
RkJQdWJsaXNoZXIy MTEyNjY3NA==